Sidebar
notes:c4eng:fall2023:projects:stl0
This is an old revision of the document!
Table of Contents
STL0
PREPARATION
INSTALL CUSTOM WIRINGPI
yourpi:~$ wget https://project-downloads.drogon.net/wiringpi-latest.deb
NOTE: domain say “dr-OH-gon”, it does NOT say “dragon”
yourpi:~$ sudo dpkg -i wiringpi-latest.deb
USING WIRINGPI: THE gpio TOOL
USING WIRINGPI: SETTING MODE OF PINS
USING WIRINGPI: WRITING TO PINS
ELECTRICITY
VOLTAGE / VOLTS
GROUND
AMPERAGE / AMPS
RESISTANCE / OHMS
DIGITAL ELECTRONICS
LIGHT EMITTING DIODE
RESISTOR
SERIES CIRCUIT
COMPONENTS
BREADBOARD
T-COBBLER / INTERFACE TO PI GPIO PINS
GPIO.0 is actually GPIO17 on your T-cobbler
LED
RESISTOR
TARGET CIRCUIT
notes/c4eng/fall2023/projects/stl0.1694705396.txt.gz · Last modified: 2023/09/14 15:29 by mgillet3
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
