Differences

This shows you the differences between two versions of the page.

--- notes:discrete:fall2022:projects:rle1 [2022/10/03 19:13] – [PROGRAM] hcordell
+++ notes:discrete:fall2022:projects:rle1 [2022/10/06 15:38] (current) – Added info about compression ratio. bolsen1
@@ Line 22: / Line 22: @@
 *For anybody interested in editing the wiki page, here is the dokuwiki user guide: https://www.dokuwiki.org/wiki:syntax#basic_text_formatting -Ash
+=====DATA HEADER SPECIFICATIONS=====
+(mostly the same as rle0)
+Header Format:
+byte 0: 0x72\\
+byte 1: 0x6c\\
+byte 2: 0x65\\
+byte 3: 0x58\\
+byte 4: 0x20\\
+byte 5: 0x52\\
+byte 6: 0x4c\\
+byte 7: 0x45\\
+byte 8: 0x00 (reserved)\\
+byte 9: 0x02 (version)\\
+byte 10: 0x(stride value) -- changes depending on input\\
+byte 11: 0xArgv The length of the source file name, not including NULL terminator\\
+(how many characters in Argv - 1)\\
+byte 12: The name of the source file, not including the NULL terminator\\
 ====CUSTOMISATION: variable stride====
 The stride will determine the workings of the the encoding/decoding process. In rle0, the stride was always 1, thus we had ababcc-> 1a1b1a1b2c, where we compressed runs of a single byte. For rle1, the stride given will determine how many bytes are in each run, for example a stride of two will mean we check for runs of two, which conducts as ababcc-> 2ab1cc. Since the strides are chars, they will hold any value between 1-255, and so each of these values should be valid for run length.
@@ Line 55: / Line 77: @@
 =====OUTPUT SPECIFICATIONS=====
+Just like what we did in rle0, the rle1's encoder should output the original file's length, the encoded file length, followed by the compression ratio. The output is not strict, as long as you have the correct input file length, output file length, and compression ratio. The compression ratio can be calculated by the following equation: 'Output Length / Input Length'. Make sure in your code to set the type of the variable holding the compression ratio to 'double' or 'float'. You may also want to take a look at the C output format specifiers for a prettier output.
+Example:
+         Input File length: 100
+         Output File length: 40
+         Compression ratio: .40 or 40%
 =====VERIFICATION=====
+**NOTE** Verification using ./check may not work. If this is the case, then run manual checks. To do this, run the sample and use the stride that is in the header of the sample output you are comparing to (Byte 10). The stride used is also in the file name.
+To run the check file provided to you when you grabbed the project, run ./check (linux-based system, may vary on different OS).
+You can also manually verify by encoding/decoding a file, and checking if it has the same md5sum as the file with or without the .rle extension depending on if you encoded or decoded. To do this, run your encoder/decoder, and enter md5sum (output file), again, linux-based system, may vary on a different OS.

Lab46 Wiki

User Tools

Site Tools

Differences

Page Tools