notes:comporg:spring2025:projects:mtb3
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
| notes:comporg:spring2025:projects:mtb3 [2025/03/10 15:21] – created - external edit 127.0.0.1 | notes:comporg:spring2025:projects:mtb3 [2025/04/03 04:11] (current) – [logic for accessing] bdildine | ||
|---|---|---|---|
| Line 4: | Line 4: | ||
| ====manifestation in memory==== | ====manifestation in memory==== | ||
| + | When looking at the bricks in breakout, it makes sense to see them as an array, which are a very simple concept in assembly, as it is just a contiguous chunk in memory. That said, when initializing our block field, we are just initializing an area in memory with specific values to access later on.\\ | ||
| + | When looking to initialize our memory, we have to consider everything we may use for our blocks, which may be just an xpos, ypos, and active flag, and give enough space to hold everything. There are multiple ways of going about this depending to the constraints you have; if you are looking for space efficiency, you may want to pack your data into one word each, then decoding later when we need to use it; if you are looking for ease of use, you may just want to give each attribute its own word in memory. To take the latter approach, you will want to initialize each attribute based on a starting position, then move that starting position along to affect each block. This may look like: | ||
| + | < | ||
| + | _init: | ||
| + | mov R0, 0x00000000 ; memaddr | ||
| + | mov R1, 1 ; activeflag | ||
| + | mov R2, 0 ; xpos | ||
| + | mov R3, 0 ; ypos | ||
| + | _brickinitloop | ||
| + | mov [R0], R1 | ||
| + | mov [R0+1], R2 | ||
| + | mov [R0+2], R3 | ||
| + | iadd R0, 3 | ||
| + | iadd R2, | ||
| + | ; add some sort of break condition | ||
| + | jmp _brickinitloop | ||
| + | </ | ||
| ====logic for accessing==== | ====logic for accessing==== | ||
| + | If you gave each attribute of the brick its own memory address (for example active flag, xpos, ypos) we can access them by going back to that address. | ||
| + | If you used 0x00000000 as your starting address for defining the brick field for example, you would set a register to that memory address and then read from it and its following addresses as such: | ||
| + | < | ||
| + | | ||
| + | _brick_activeflag: | ||
| + | | ||
| + | | ||
| + | | ||
| + | ; repeat loop if not active | ||
| + | </ | ||
| + | Similarly when displaying the bricks we can use [R0+1] and [R0+2]. | ||
| + | Since R0 is the memory address of our brick and each brick has three addresses (active flag, xpos, ypos), | ||
| + | [R0] is the active flag [R0+1] is the xpos and [R0+2] is the ypos. | ||
notes/comporg/spring2025/projects/mtb3.1741620090.txt.gz · Last modified: 2025/03/10 15:21 by 127.0.0.1
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
