notes:c4eng:fall2022:projects:fso0
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| notes:c4eng:fall2022:projects:fso0 [2022/11/10 03:58] – [APPLICATION] mward14 | notes:c4eng:fall2022:projects:fso0 [2022/11/10 06:06] (current) – [APPLICATION] cmille71 | ||
|---|---|---|---|
| Line 258: | Line 258: | ||
| 1. Download the library | 1. Download the library | ||
| - | Run: | + | |
| + | Run: | ||
| < | < | ||
| - | -Enter the newly created directory | + | 2. Enter the newly created directory |
| - | cd lcd | + | |
| + | < | ||
| - | -Install the library | + | 3. Install the library |
| - | sudo ./ | + | |
| + | < | ||
| - | if you are given the error ' | + | if you are given the error ' |
| - | chmod a+x setup.sh | + | < |
| - | to give setup.sh permission to excecute | + | to give setup.sh permission to excecute |
| - | -Reboot your pi | + | 4. Reboot your pi |
| 5. View or run any demos | 5. View or run any demos | ||
| - | you can view or run any of the programs labeled demo after running ls. | + | |
| + | You can view or run any of the programs labeled demo after running ls. | ||
| Programs can be excecuted by running: | Programs can be excecuted by running: | ||
| - | python FILENAME.py | + | < |
| The code can also be viewed by using nano. | The code can also be viewed by using nano. | ||
| - | ====DEMONSTRATION==== | ||
| - | =====COMPONENT 12===== | ||
| - | ====DESCRIPTION==== | + | // |
| - | ====APPLICATION==== | + | **Description** |
| + | The GY-521 contains both a 3-Axis Gyroscope and a 3-Axis accelerometer allowing measurements of both independently, | ||
| + | **Specification** | ||
| + | Accelerometer ranges: ±2, ±4, ±8, ±16g | ||
| + | Gyroscope ranges: ± 250, 500, 1000, 2000 °/s | ||
| + | Voltage range: 3.3V - 5V (the module include a low drop-out voltage regulator) | ||
| + | This simple module contains everything required to interface to the Arduino and other controllers via I2C (use the Wire Arduino library) and give motion sensing information for 3 axes - X, Y and Z. | ||
| + | ====APPLICATION==== | ||
| + | The GY-521 can be used to measure the orientation of the device. It can sense motion including vertical and horizontal rotation. There are a lot of practical uses of gyroscope especially in aerospace. It can be used as a stability assistance device to make sure that a rocket, a spacecraft, or an aircraft maintains the correct orientation. | ||
| ====DEMONSTRATION==== | ====DEMONSTRATION==== | ||
notes/c4eng/fall2022/projects/fso0.1668052707.txt.gz · Last modified: 2022/11/10 03:58 by mward14
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
