haas:fall2020:common:projects:led2
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
haas:fall2020:common:projects:led2 [2020/09/18 09:28] – [The Circuit to Construct] wedge | haas:fall2020:common:projects:led2 [2020/09/20 16:53] (current) – [Program] wedge | ||
---|---|---|---|
Line 147: | Line 147: | ||
Take note of how everything is being plugged in, and what connection on the T-cobbler is being utilized. | Take note of how everything is being plugged in, and what connection on the T-cobbler is being utilized. | ||
- | |||
- | Notice how the circuit runs from ground to LED to resistor to pin " | ||
Please keep in mind: | Please keep in mind: | ||
Line 210: | Line 208: | ||
* then, one at a time (on the same constant update delay), deactivate each LED, from left to right, until each LED is no longer lit | * then, one at a time (on the same constant update delay), deactivate each LED, from left to right, until each LED is no longer lit | ||
* the program can continually perform this swooshing pattern, but it should do the whole pattern at least once | * the program can continually perform this swooshing pattern, but it should do the whole pattern at least once | ||
+ | |||
+ | {{ : | ||
====Grabbing project resources (on lab46)==== | ====Grabbing project resources (on lab46)==== | ||
I have prepared a **grabit** for resources related to this project. To obtain: | I have prepared a **grabit** for resources related to this project. To obtain: |
haas/fall2020/common/projects/led2.txt · Last modified: 2020/09/20 16:53 by wedge