Differences

This shows you the differences between two versions of the page.

--- haas:fall2020:common:projects:led2 [2020/09/03 17:10] – [Program] wedge
+++ haas:fall2020:common:projects:led2 [2020/09/18 09:29] – [The Circuit to Construct] wedge
@@ Line 106: / Line 106: @@
 {{ :haas:fall2020:common:projects:breadboardlogic.png?400 |}}
+Here's a good video overview of the functionality of a breadboard:
+  * https://www.youtube.com/watch?v=6WReFkfrUIk
 ====(1) T-cobbler and data cable====
 In your kit should be a T-shaped device (known as the "T-cobbler" with some aspect of pin names silkscreened on it, and a 40-pin ribbon cable). Colors may vary, but essentially it looks like this:
@@ Line 143: / Line 147: @@
 Take note of how everything is being plugged in, and what connection on the T-cobbler is being utilized.
-Notice how the circuit runs from ground to resistor to LED to pin "GPIO17/Physical pin 11/Wiring Pi pin 0"
 Please keep in mind:
@@ Line 297: / Line 299: @@
 <code>
 :led2:final tally of results (52/52)
-*:led2:post picture of unpowered layout to #desig and get approval [6/6]
+*:led2:post picture of unpowered layout to #desig and get approval [8/8]
-*:led2:post picture to #desig by Sunday before deadline [6/6]
+*:led2:post picture to #desig by Sunday before deadline [4/4]
-*:led2:post picture of powered LEDs in layout to #desig [6/6]
+*:led2:post picture of powered LEDs in layout to #desig [8/8]
-*:led2:grabit on the code on lab46 by Sunday before deadline [3/3]
+*:led2:grabit on the code on lab46 by Sunday before deadline [4/4]
-*:led2:led2.c code adequately expanded per project requirements [6/6]
+*:led2:led2.c code adequately modified per project requirements [12/12]
-*:led2:led2.c comments describing what is happening [6/6]
+*:led2:led2.c comments describing what is happening [8/8]
-*:led2:updated code is pushed to lab46 repository [6/6]
+*:led2:updated code is pushed to lab46 repository [8/8]
 </code>