Differences

This shows you the differences between two versions of the page.

--- haas:fall2020:common:projects:led0 [2020/09/18 09:26] – [(1) breadboard] wedge
+++ haas:fall2020:common:projects:led0 [2020/09/18 09:28] (current) – [The Circuit to Construct] wedge
@@ Line 107: / Line 107: @@
 {{ :haas:fall2020:common:projects:breadboardlogic.png?400 |}}
-Here's a good video overview of the functionality of a breadboard: https://www.youtube.com/watch?v=6WReFkfrUIk
+Here's a good video overview of the functionality of a breadboard:
+  * https://www.youtube.com/watch?v=6WReFkfrUIk
 ====(1) T-cobbler and data cable====
 In your kit should be a T-shaped device (known as the "T-cobbler" with some aspect of pin names silkscreened on it, and a 40-pin ribbon cable). Colors may vary, but essentially it looks like this:
@@ Line 145: / Line 147: @@
 Take note of how everything is being plugged in, and what connection on the T-cobbler is being utilized.
-Notice how the circuit runs from ground to resistor to LED to pin "GPIO17/Physical pin 11/Wiring Pi pin 0"
+Notice how the circuit runs from ground to LED to resistor to pin "GPIO17/Physical pin 11/Wiring Pi pin 0"
 Before you seek to actually test your circuit, please get verification to proceed from the class channel on discord by posting a clear picture of everything. There are MANY moving parts, and especially as we have our first exposure, it is best to insert as many quality control checks as possible to ensure the greatest chances of mistakes are mitigated.