Differences

This shows you the differences between two versions of the page.

--- haas:fall2020:common:projects:clr2 [2020/10/10 16:42] – [Submission] wedge
+++ haas:fall2020:common:projects:clr2 [2020/11/04 12:51] (current) – [Wiring up our circuit] wedge
@@ Line 128: / Line 128: @@
 So, your ultimate circuit will have FOUR independent inputs- red control, green control, and blue control (all buttons), and then the DIRECTION switch (increase/decrease). FOUR GPIOs in INPUT mode are needed.
+====Final result====
+Once all connected, your circuit should allow for directional, per-colour adjustment of each of the three colours. Here's an animated gif of one such circuit in action:
+{{ :haas:fall2020:common:projects:clr2_working_example.gif |}}
 =====Program=====
 Your program to implement for this project involves using the wired up RGB LED, the three buttons, and the switch, to do the following:
@@ Line 146: / Line 151: @@
 When done and ready to submit, on lab46: **make submit**
+=====Strategy=====
+In general, you will want your completed program to perform in the manner described as follows (in English-like pseudocode):
+<code>
+LOOP TO KEEP PROGRAM GOING
+        IF SWITCH IS IN POSITION 1:
+                DIR <- +10
+        ELSE
+                DIR <- -10
+        END IF
+        IF RED BUTTON IS PRESSED:
+                REDCOLOR <- REDCOLOR + DIR
+        END IF
+        IF GREEN BUTTON IS PRESSED:
+                GREENCOLOR <- GREENCOLOR + DIR
+        END IF
+        IF BLUE BUTTON IS PRESSED:
+                BLUECOLOR <- BLUECOLOR + DIR
+        END IF
+        SETRED(REDCOLOR)
+        SETGREEN(GREENCOLOR)
+        SETBLUE(BLUECOLOR)
+        DELAY
+END LOOP
+</code>
 =====Submission=====
 To successfully complete this project, the following criteria must be met:

Lab46 Wiki

User Tools

Site Tools

Differences

Page Tools