Corning Community College
ENGR1050 C for Engineers
To continue our exploration of interfacing electronics with our pi's, and writing a program that controls it, and collaboratively authoring and documenting the project and its specifications.
To assist with consistency across all implementations, data files for use with this project are available on lab46 via the grabit tool. Be sure to obtain it and ensure your implementation properly works with the provided data.
lab46:~/src/SEMESTER/DESIG$ grabit DESIG PROJECT
Your task is to expand upon last week's project by scaling it to six independently GPIO-controlled LEDs, optimize the binary counting process with a loop and bitwise logic, and to incorporate a button, which will influence the direction of counting (normal upward flow when not pressed, reverse flow during a button press).
Contributing to project documentation is also a core part of this project. If from reading the existing documentation or through your own exploring, you find something lacking, unclear, or outright missing, that is an opportunity to potentially contribute content.
You want the project documentation to provide you (as if coming in with no awareness of the project) with sufficient information so as to allow you to proceed. Asking questions on the discord is a great way of getting more information that you can use to add content.
You will want to go here to edit and fill in the various sections of the document:
SET COUNTER TO ZERO AS LONG AS PROGRAM CONTINUES TO RUN: SET VALUE TO CURRENT NUMBER STORED IN COUNTER LOOKING AT BITS RANGING FROM NUM_LEDS MINUS ONE TO ZERO: SET PLACEVALUE TO TWO RAISED TO THE BIT BEING LOOKED AT SHOULD VALUE ANDED WITH PLACEVALUE BE ONE: ENABLE PLACEVALUE'S LED OTHERWISE: DISABLE PLACEVALUE'S LED NEXT LOOK (UNTIL DONE) SHOULD THE BUTTON BE PRESSED: UPDATE COUNTER TO BE ONE LESS THAN ITS CURRENT STATE SHOULD THE COUNTER GO BELOW ZERO: RESET COUNTER TO TWO RAISED TO NUM_LEDS OTHERWISE: UPDATE COUNTER TO BE ONE GREATER THAN ITS CURRENT STATE SHOULD THE COUNTER EXCEED FIFTEEN: RESET COUNTER TO ZERO KEEP GOING
To be successful in this project, the following criteria (or their equivalent) must be met:
Let's say you have completed work on the project, and are ready to submit, you would do the following (assuming you have a program called uom0.c):
lab46:~/src/SEMESTER/DESIG/PROJECT$ make submit
You should get some sort of confirmation indicating successful submission if all went according to plan. If not, check for typos and or locational mismatches.
I'll be evaluating the project based on the following criteria:
65:vcc1:final tally of results (65/65) *:vcc1:used grabit to obtain project by the Sunday prior to duedate [10/10] *:vcc1:picture of unpowered circuit to #desig for approval [10/10] *:vcc1:picture of powered circuit to #desig showing results [10/10] *:vcc1:clean compile, no compiler messages [7/7] *:vcc1:program conforms to project specifications [22/22] *:vcc1:code tracked in lab46 semester repo [6/6]